Skip to main content
Menu
US
In Vivo Preclinical Imaging

Sample Depilation (Hair Removal) Procedure for In Vivo Imaging

Section
Best Practices
Applications
Best Practices
IVISbrite Bacterial Cell Lines
IVISbrite Bioluminescent Substrates
IVISbrite Lentiviral Particles
IVISbrite Tumor Cell Lines
IVISense Fluorescent Dyes
IVISense Fluorescent Imaging Probes - Activatable
IVISense Fluorescent Imaging Probes - Targeted
IVISense Fluorescent Imaging Probes - Vascular
In Vivo Imaging
Sub Section
Sample Depilation (Hair Removal) Procedure for In Vivo Imaging
Anesthetizing a Mouse Using Ketamine Xylazine
IP Injections for IVISense Fluorescent Agents
Lateral Tail Vein Injections
Sample Depilation (Hair Removal) Procedure for In Vivo Imaging

Overview

This information is provided as an example protocol. Always be sure that IACUC or ethic committee approval is in place before beginning any experimental protocol.

In order to image on optical imaging systems such as the IVIS® instrument, subject animals need to be depilated, or have their hair removed as it can interfere with accurate imaging. The preferred method of depilation at Revvity is Nair™ Hair Removal.

Potential Cautions

In order to remove hair using Nair™, the animal must be anesthetized using an i.p. injection of Ketamine/Xylazine. An approved IACUC procedure for your institution should be used with appropriate dosing.

Nair™ can be a skin irritant for both humans and animals. Nair™ should not be left on animal for longer than 5-10 minutes and should be thoroughly washed away after depilation.

Procedure

  1. Lab coats and gloves should be worn at all times when in the animal facility. Goggles can also be worn if needed.  
  2. Gather animals to be depilated and Nair™.  
  3. Mix ketamine/xylazine in a 1.5 mL microcentrifuge tube  
  4. Collect enough ketamine/xylazine mixture for the number of animals to be depilated in a 1 mL syringe with a 27 gauge needle attached. The dose per animal can be calculated as appropriate. Be sure to weigh the animal prior to injecting to ensure proper amount.  
  5. Remove all air bubbles from the syringe.
  6. Inject the calculated dose of ketamin/xylazine into the animal intrapertioneally.  
  7. Observe the animals for signs of consciousness. When animal appears induced, add a few drops of Nair™ to the area in need of depilation.  
  8. Gently massage the Nair™ around the areas to be depilated.  
  9. Allow the animal to rest comfortably for 5-10 minutes. Placing animal on heating pad after depilation ensures maximum comfort.  
  10. Rinse the areas where Nair™ has contacted thoroughly. Ensure that the mouse does not swallow or breathe in any water.  
  11. Repeat steps 8-10 if needed.  
  12. Once mouse has been depilated fully, move to a heating pad or to its original cage. 

For research use only. Not for use in diagnostic procedures.

The information provided above is solely for informational and research purposes only. The information does not constitute medical advice and must not be used or interpreted as such. Consult a qualified veterinarian or researcher for specific guidance on these techniques.  Revvity assumes no liability or responsibility for any injuries, losses, or damages resulting from the use or misuse of the provided information. The information is provided on an "as is" basis without warranties of any kind. Users are solely responsible for complying with all relevant laws, regulations, and institutional animal care and use committee (IACUC) guidelines in their use of the information provided.

 

ON THIS PAGE